AudioCodes 420HD - 48 Configuring System Logging (Syslog); Analyzing and Debugging Traffic Using Regular Syslog; Figure 48-1: Web Interface -System Logging

Administrator's Manual 48. Configuring System Logging (Syslog)
Version 2.2.8 259 400HD Series IP Phones
48 Configuring System Logging (Syslog)
System logging (Syslog) can be configured using the Web interface or configuration file.
Two Syslog options are available:

Regular Syslog (see the next section)

Lightweight Syslog (see Section 48.1.2).
48.1.1 Analyzing and Debugging Traffic using Regular Syslog
This section shows how to use the System Logging (Syslog) feature for traffic analysis and
debugging. The feature can be configured using the Web interface or Configuration File.
 To configure system logging using the Web interface:
1. Access the System logging page (Status & Diagnostics tab > Diagnostics menu >
Logging).
Figure 48-1: Web Interface –System Logging
2. Configure using the table below as reference, and then click Submit.
 To configure system logging using the configuration file:
• Use the table below as reference.
Table 48-1: Syslog Parameters
Parameter Description
Activate
[system/watchdog/enabled]
Enables the system watchdog. Possible values are:
• Disable = No Syslog.
• Network = Syslog is sent to the Syslog server.
(Recommended).
• Console = Syslog is sent to the phone console.
(You need to connect a serial cable to view the
logs. This causes delays in phone operation).
• Both = Syslog sends to the Syslog server AND
the console.
Note: It is recommended to leave this parameter at