AudioCodes 420HD - Table A-2: Broadsoft Server - Shared Call Appearance - Identity;Device Profile Type

400HD Series IP Phones
Administrator's Manual 280 Document #: LTRT-11950
2. On the Shared Call Appearance page shown in the figure above, click Add to configure
an 'Identity/Device Profile Type', and then use the table below as reference to configure
the parameters.
Table A-2: BroadSoft Server - Shared Call Appearance – Identity/Device Profile Type
Parameter Description
Alert all appearances for Click-to-Dial calls See BroadSoft's documentation for detailed
information.
Select this option when you want your
Click-To-
Dial calls to ring all phones that have your
line appearance.
Clear the option if you prefer your line to ring your
phone only.
Alert all appearances for Group Paging calls See BroadSoft's documentation for detailed
information.
Allow call retrieve from another location See BroadSoft's documentation for detailed
information.
Select this option when you use a feature access
code to automatically retrieve a call that was
answered at another Shared Call Appearance of
your number.
Multiple Call Arrangement See BroadSoft's documentation for detailed
information.
Select On
to allow multiple calls using your phone
number / ID to be dialed or answered
simultaneously across all Shared Call
Appearances of your number.
Select Allow bridging between locations when
you want to use a feature access code to bridge a
3-way conference call automatically for any call
that has been answered at another Shared Call
Appearance of your number.
Select Enable Call Park notification for the
phone to alert the user visually and audially when a
parked call is received.
Bridge Warning tone See BroadSoft's documentation for detailed
information.
Select the type of Bridge Warning tone treatment
you prefer when you bridge and join a call u
sing a
feature access code.
Select None
to apply no tone alert treatment upon
your entry to the call.
Select Barge-in only
to provide a single tone alert.
Select Barge-in and repeat every 30 seconds
to
provide a tone alert at that interval.
3. Click the Edit link adjacent to the selected Line/Port to modify a specific phone that has
a Shared Call Appearance of your line.
4. Click OK.