AudioCodes 420HD - Configuring Onhook Disconnect When Held; Disabling the HOLD Key; Table 23-13: Disabling the HOLD Key

400HD Series IP Phones
Administrator's Manual 152 Document #: LTRT-11950
23.13 Disabling the HOLD Key
This section shows how to disable the HOLD key on the phone's keypad.
 To disable the HOLD key using the Configuration File:
• Use the table below as reference.
Table 23-13: Disabling the HOLD Key
Parameter Description
[system/disable_hold_button]
Disables the HOLD key on the phone's keypad. The
HOLD key is used to place a call on hold, or to resume a
held call.
23.14 Configuring Onhook Disconnect when Held
Note: Only applies to AudioCodes' SIP-100 and SIP-200 devices.
This section shows how to configure whether the device automatically goes idle (i.e.,
on-hook) when the last remaining call is disconnected.
 To configure onhook disconnect when held, using the Configuration File:
• Use the table below as reference.
Table 23-14: Onhook Disconnect when Held
Parameter Description
[voip/onhook_disconnect_when_held/enabled]
Choose either:
 [0] Disable (default) - If the receiver is placed on-hook
after a call is put on hold, the call is put on speaker
rather; it isn't disconnected.
 [1] Enable - If the receiver is placed on-hook after a
call is put on hold, the call is disconnected.