AudioCodes 420HD - Configuring Daylight Saving Time; Figure 13-2: Web Interface - NTP & Time Settings; Figure 13-3: Web Interface - Daylight Saving Time; Table 13-2: Daylight Saving Time Parameters

400HD Series IP Phones
Administrator's Manual 70 Document #: LTRT-11950
13.1 Configuring Daylight Saving Time
You can configure Daylight Saving Time using the Web interface or Configuration File.
 To configure Daylight Saving Time using the Web interface:
1. Access the Date and Time page (Configuration tab > Advanced Applications menu >
Date and Time) as described above.
2. Set the 'Active' parameter to Enable; the page shown below opens.
Figure 13-2: Web Interface - NTP & Time Settings
3. Set the 'Obtain Time Zone from DHCP' parameter to Disable; the Daylight Saving Time
page shown below opens:
Figure 13-3: Web Interface – Daylight Saving Time
4. Configure the settings using the table below as reference.
 To configure Daylight Saving Time using the Configuration File:
• Use the table below as reference.
Table 13-2: Daylight Saving Time Parameters
Parameter Description
Active
[system/daylight_saving/activate]
Determines whether the phone automatically
detects the Daylight Saving Time for the selected
Time Zone.
 [DISABLE] Disable (default)

[ENABLE]
Enable