AudioCodes 420HD - 13 Configuring Date and Time Manually; Figure 13-1: Web Interface - Date and Time; Table 13-1: Date Display Format

Administrator's Manual 13. Configuring Date and Time Manually
Version 2.2.8 69 400HD Series IP Phones
13 Configuring Date and Time Manually
Note: By default, date and time settings are automatically provisioned via the enterprise
DHCP server when the phone is connected to the Internet and to the power supply, but
you can manually change them if required. This section shows how.
The phone automatically retrieves date and time from a Network Time Protocol (NTP) server
when connected to the internet. To configure the NTP server for automatic provisioning of
date and time, see Section 13.2. NTP is a protocol for distributing Coordinated Universal
Time (UTC) by synchronizing the clocks of computer systems over packet-switched,
variable-latency data networks. Date/time can also be manually configured in the Web
interface.
 To manually configure date and time using the Web interface:
1. Access the Date and Time page (Configuration tab > Advanced Applications menu >
Date and Time).
Figure 13-1: Web Interface - Date and Time
2. Configure the 'Set System Time' parameter.
3. Set the 'Time Display Format' to 24 Hours or 12 Hours
4. Set the 'Date Display Format' to European or American. Refer to the table below.
5. Click Submit.
 To configure date and time using the Configuration File:
• Use the table below as reference.
Table 13-1: Date Display Format
Parameter Description
Date Display Format
[system/ntp/date_display_format]
Select either:
 EUROPEAN (default)
 AMERICAN
The European date format is DDMMYYYY.
The American format is MMDDYYYY.