AudioCodes 420HD - Using Previously Loaded Certificates

Administrator's Manual 30.Loading a Certificate
Version 2.2.8 209 400HD Series IP Phones
30.4 Using Previously Loaded Certificates
If you have upgraded to this version and your phones have pre-installed certificates, then the
CA configuration parameter values from previous versions are translated to version 2.2.2
parameter values as described below.
Note: It is highly recommended to change the CA configuration by using the methods
described in the above sections.

Certificate file settings for versions prior to version 2.2.2:
security/ca_certificate_uri= xxx
security/certificate_uri=zzz
security/private_key_uri=yyy
where:
xxx is the uri of the root CA
zzz is the uri of the certificate file
yyy is the uri of the private key file

Certificate file settings translated to version 2.2.2:
security/autoupdate_certificate_uri=zzz
security/autoupdate_private_key_uri= yyy
security/ca_certificate/0/uri=xxx
security/ca_certificate/1/uri=
security/ca_certificate/2/uri=
security/ca_certificate/3/uri=
security/ca_certificate/4/uri=
security/ieee802_1x_certificate_uri=zzz
security/ieee802_1x_private_key_uri= yyy
security/sip_certificate_uri= zzz
security/sip_private_key_uri= yyy
Note: The CA configuration parameters prior to version 2.2.2 are longer used on the IP
Phone.