AudioCodes 420HD - Configuring Using the Configuration File; Figure 27-2: Web Interface - Enable Barge-In

Administrator's Manual 27. Configuring Multicast Paging
Version 2.2.8 195 400HD Series IP Phones
Figure 27-2: Web Interface – Enable Barge-in
 To enable Barge-in using the Configuration File:
• Use the table below as reference.
Table 27-2: Barge-in Parameters
Parameter Description
[voip/services/allow_barge_in/enabled]
Enables paging to interrupt (i.e., barge into) a call
currently in progress.
 [0] Disabled (default)
 [
1
] Enabled
Note: See the IP Phone User's Manual for examples.
27.2 Configuring Using the Configuration File
This section shows how to configure the multicast paging feature using the configuration file.
 To enable Multicast Paging using the Configuration File:
• Use the table below as reference.
Table 27-3: Paging Parameters
Parameter Description
[voip/services/group_paging/enabled]
Enables group paging.
 [0] Disabled (default)
 [
1
] Enabled
[voip/services/group_paging/group/0-11/activated]
Sets the group to which to page.
Default: Group 0
[voip/services/group_paging/group/0-11/multicast_addr]
Sets the multicast address for group 0-11 to
which to page. Default: 224.0.0.0
[voip/services/group_paging/group/0-11/name]
Sets the paging group name to display in the
LCD.
[voip/services/group_paging/group/0-11/port]
Sets the multicast port for group 0 to which to
page. Default: 8888