AudioCodes 420HD - 19 Configuring Ring Tones; Configuring Distinctive Ring Tones; Figure 19-1: Web Interface - Distinctive Ringing; Table 19-1: Distinctive Ringing Parameters

Administrator's Manual 19. Configuring Ring Tones
Version 2.2.8 119 400HD Series IP Phones
19 Configuring Ring Tones
This section shows how to configure and upload ring tones to the phone.
19.1 Configuring Distinctive Ring Tones
You can configure a phone to ring in a distinct tone per caller, thus facilitating caller
recognition and saving others from unnecessary disruptions to their activities if the phone is
shared.
 To configure a distinctive ring tone using the Web interface:
1. Access the Tones page (Configuration tab > Personal Settings menu > Tones) and
scroll down until 'Distinctive Ringing Setting'.
Figure 19-1: Web Interface – Distinctive Ringing
2. Configure using the table below as a reference.
 To configure a distinctive ring using the Configuration File:
• Use the table below as a reference.
Table 19-1: Distinctive Ringing Parameters
Parameter Description
[voip/distinctive_ringing/0-4/ringtone]
A name to assign to a distinctive ring tone: Ring01, Ring02,
Ring03 and Ring04.
If you do not enter a name, the
phone assigns the tone's file name (without the .wav
file extension) as the name of the tone
[voip/distinctive_ringing/0-4/type]
The string of the 'Alert-Info' header in the INVITE message,
configured in the SIP proxy or application server. Used to
distinguish between different calls.