AudioCodes 420HD - Configuring Automatic Dialing; Figure 23-5: Web Interface - Dialing - Automatic Dialing; Table 23-6: Automatic Dialing Parameters

400HD Series IP Phones
Administrator's Manual 144 Document #: LTRT-11950
23.6 Configuring Automatic Dialing
Automatic Dialing can be configured using the Web interface or Configuration File.
 To define Automatic Dialing using the Web interface:
1. Access the Dialing page (Configuration tab > Voice Over IP menu > Dialing).
Figure 23-5: Web Interface - Dialing - Automatic Dialing
2. Configure dialing options according to the parameters in the table below, and then click
Submit.
 To define Automatic Dialing using the Configuration File:
• Use the table below as reference.
Table 23-6: Automatic Dialing Parameters
Parameter Description
Activate
[voip/dialing/auto_dialing/enabled]
Determines whether automatic dialing is enabled (i.e.,
phone number is automatically dialed when you
off-hook the phone).
 [0] Disable (default)
 [1] Enable
Timeout
[voip/dialing/auto_dialing/timeout]
Timeout (in seconds) before automatic dialing occurs
after the phone is off-hooked. When set to 0, automatic
dialing is performed immediately.
The valid range is 0 to 120. The default value is 15.
Destination Phone Number
[voip/dialing/auto_dialing/destination]
The number that is automatically dialed when the
phone is off-hooked.
The valid value can be up to 32 characters.