Administrator's Manual A. Configuring Phones in Server-Specific Deployments
Version 2.2.8 275 400HD Series IP Phones
d. Define the Application Server Address:
♦ Same address as SIP Registrar: From the 'Use Registrar as Application
Server Address'
(voip/services/busy_lamp_field/application_server/use_registrar parameter)
drop-down list, select Enable. The Registrar's address is used as the
application server's address, defined by the parameter
voip/signalling/sip/sip_registrar/addr (refer to Section 17.2).
♦ Unique address: From the 'Use Registrar as Application Server Address'
drop-down list, select Disable, and then in the 'Application Server Address or
Domain Name' field
(voip/services/busy_lamp_field/application_server/addrparameter), enter
the IP address or domain name of the application server.
4. Click Submit.
5. Define speed dial keys with the BLF feature (see Section 26).
A.1.2 Configuring Call Forwarding
Note: This section is only applicable to 430HD and 440HD phones.
A.1.2.1 Using the IP Phone's LCD
Call Forwarding can be configured in a BroadSoft environment using the phone's LCD.
Note: Before configuring Call Forwarding using the IP phone's LCD, make sure 'Feature
Key Synchronization' in the phone's Web interface is disabled (see Section A.1.4).
To configure call forwarding using the phone's LCD:
See the User's Manual for detailed information.
A.1.2.2 Using BroadSoft's BroadWorks
Call Forwarding can also be configured using the BroadSoft BroadWorks application
platform. Call Forwarding status can also be retrieved using it.
Note: To enable BroadWorks-managed Call Forwarding, you must first enable 'Feature
Key Synchronization' using the Web interface (see Section A.1.4).
To Next Page
Loading...
