400HD Series IP Phones
Administrator's Manual 160 Document #: LTRT-11950
24.3 Configuring Ringer Volume
The ringer volume can be configured using the Configuration File.
Note: It's strongly advisable not to change the default values.
To configure the ringer volume using the Configuration File:
• Use the table below as reference.
Table 24-3: Ringer Volume Parameters
Parameter Description
Ringer Volume
voip/audio/gain/ringer_signal_level
Ringing tone volume. This volume can be modified
on-the-fly by pressing the phone's VOLUME key when the
phone is in idle state.
The valid range is [-31] to [31] dB
To Next Page
Loading...
