AudioCodes 420HD - Loading the Client Certificate to the Phone; Loading the Client Certificate to the Phone Using the Configuration File; Figure 30-2: Web Interface - Client Certificate

400HD Series IP Phones
Administrator's Manual 206 Document #: LTRT-11950
Parameter Description
Root CA 4
[security/ca_certificate/3/uri=]
The fourth root CA certificate loaded to the phone.
Root CA 5
[security/ca_certificate/4/uri=]
The fifth root CA certificate loaded to the phone.
30.2 Loading the Client Certificate to the Phone
The section shows how to load the Client Certificate to the phone.
 To load the Client Certificate to the phone:
1. Open the Client Certificate page (Configuration tab > Security menu > Client
Certificate).
Figure 30-2: Web Interface – Client Certificate
30.2.1 Loading the Client Certificate to the Phone using the
Configuration File
This section shows how to load a Client Certificate file to the phone using the configuration
file.
Note: Using this method, client certificates files are loaded to the phone when it is
powered up.
 To load a client certificate file using the configuration file:
• Use the table below as reference.
Table 30-2: Client Certificate Parameters
Parameter Description
Certificate
[security/sip_certificate_uri]
Loads the Client Certificate for SIP TLS (SIP calls with
Transport Layer Security) to the phone.
Private Key
[security/sip_private_key_uri]
Loads the Client Private Key for SIP TLS (SIP calls
with Transport Layer Security) to the phone.
Certificate
[security/ieee802_1x_certificate_uri]
Loads the Client Certificate for 802.1X Authentication
to the phone.