AudioCodes 420HD - Figure 17-8: Web Interface - Quality of Service; Table 17-7: SIP Qos Parameters; Configuring SIP Qos

400HD Series IP Phones
Administrator's Manual 106 Document #: LTRT-11950
17.6 Configuring SIP QoS
SIP Quality of Service (QoS) can be configured using the Web interface or Configuration
File.
 To configure SIP QoS using the Web interface:
1. Access the Signaling Protocol page (Configuration tab > Voice Over IP menu >
Signaling Protocols).
Figure 17-8: Web Interface - Quality of Service
2. Configure the SIP QoS parameters using the table below as reference, and then click
Submit.
 To configure SIP QoS using the Configuration File:
• Use the table below as reference.
Table 17-7: SIP QoS Parameters
Parameter Description
Type of Service (ToS)
[voip/signalling/sip/tos]
QoS in hexadecimal format. This is a part of the IP header that defines
the type of routing service to tag outgoing signalling packets originated
from the phone. It informs routers that this packet must receive a specific
QoS.
The default value is 0x60.
Values can be set in decimal (e.g. 96) or hexadecimal (e.g. 0x60).
For information on configuring RTP QoS, see Section 20.3 on page 127.