AudioCodes 420HD - Figure 23-7: Web Interface - Services - BLF Support - Call Pick up; Table 23-9: Call Pick up Parameters; Configuring Call Pick up

Administrator's Manual 23. Configuring Supplementary Services
Version 2.2.8 147 400HD Series IP Phones
23.9 Configuring Call Pick Up
Note: Call Pick Up only applies to the 430HD and 440HD phones.
Since the Call Pick Up feature is relevant only when Busy Lamp Field (BLF) is activated, the
call pickup parameters appear as BLF related parameters.
 To configure Call Pick Up using the Web interface:
1. Access the Services page (Configuration tab > Voice Over IP menu > Services).
Figure 23-7: Web Interface - Services - BLF Support - Call Pick Up
2. Under the BLF Support section, set the 'Activate' field to Enable.
3. Configure Call Pick Up according to the parameters in the table below, and then click
Submit.
Table 23-9: Call Pick Up Parameters
Parameter Description
Call Pick Up
[voip/services/call_pickup/enabled]
Allows call pickup by pressing on the relevant BLF
key when the remote phone's state is 'ringing'.
 [0] Disable

[1] Enable
Access code
[voip/services/call_pickup/access_code]
Allows a user to answer another's call by pressing a
user-defined sequence of phone keys. The default
sequence is **. The user dials the sequence + the
other user's phone number; the incoming call from
the other phone is forwarded to the user's phone.
For example, to pick up a call for extension 5000,
dial **5000.