400HD Series IP Phones
Administrator's Manual 180 Document #: LTRT-11950
26.2 Configuring Programmable Keys
Note: Applies to the 430HD and 440HD phone models.
26.2.1 430HD and 440HD Phones
Six programmable keys are located adjacent to the LCD. There are three on each side.
They're labeled 1-6 in the Web interface and 12-17 in the Configuration File.
You can configure them as
SIP accounts (extension lines) (see the next section)
Speed Dials / Speed Dials+BLFs (see the previous section)
Key Events such as MISSED_CALLS (see Section 26.2.1.2)
To access the Programmable Keys in the Web interface:
1. Access the Programmable Keys page (Configuration tab > Personal Settings menu >
Programmable Keys).
Figure 26-3: Web Interface – Programmable Keys (430HD/440HD Phones)
2. Refer to Table 26-3 when performing configuration for the 430HD/440HD phones.
Table 26-3: Programmable Keys Parameters (430HD/440HD Phones)
Parameter Name Description
Line Key
Select 1-6. Defines one of the six softkeys located on either side of the LCD
(three on either side) as an extension line (SIP account).
Users are disabled from configuring Programmable Keys as Line Keys. The
first two Programmable Keys are by default set to lines. The other four
Programmable Keys are by default empty. Users cannot configure all six as
Line Keys, neither in the phone LCD nor in the Web interface. The option to
assign a line (SIP account) is removed. See also Section. 26.2.1.1.
Key Type
Select either:
SIP Account
SPEED DIAL
SPEED DIAL+BLF
Key Event
Key Label
Enter a Label for the key reflecting the event, for example, enter Dialed in the
'Key Label' field if you're programming a Dialed Calls Key Event. The label
will appear in the LCD.
Paging Group Name
The name of the Paging Group. All phone extensions assigned to this group
are paged when a message is multicast from an extension in the group.
To Next Page
Loading...
