AudioCodes 420HD - 25 Configuring the Phone Directory; Configuring the Corporate Directory; Configuring the LDAP-Based Corporate Directory; Figure 25-1: Web Interface - LDAP

Administrator's Manual 25. Configuring the Phone Directory
Version 2.2.8 171 400HD Series IP Phones
25 Configuring the Phone Directory
This section shows how to configure the phone directory.
25.1 Configuring the Corporate Directory
The Corporate Directory can be configured using the Web interface or Configuration File.
25.1.1 Configuring the LDAP-based Corporate Directory
This section shows how to configure Lightweight Directory Access Protocol (LDAP), which is
an application protocol for accessing and maintaining distributed directory information
services over an IP network. It is fully described under RFC 4510.
 To configure LDAP using the Web interface:
1. Access the LDAP page (Configuration tab > Advanced Applications > LDAP). If
LDAP is set to Enable, extended configuration parameters are displayed.
Figure 25-1: Web Interface - LDAP
3. Configure the LDAP settings according to the parameters in the table below, and
then click Submit.
 To configure LDAP using the Configuration File:
• Use the table below as reference.
Table 25-1: LDAP Parameters
Parameter Name Description
Active
[system/ldap/enabled]
Enables or disable LDAP.
Server Address
[system/ldap/server_address]
Defines the IP address or URL of the LDAP
server.