AudioCodes 420HD - Configuring SIP Reject Code; Figure 17-9: Web Interface - General Parameters - Reject Code; Table 17-8: Reject Code Parameter

Administrator's Manual 17. Configuring SIP Settings
Version 2.2.8 107 400HD Series IP Phones
17.7 Configuring SIP Reject Code
Reject Code can be configured using the Web interface or Configuration File.
 To configure Reject Code using the Web Interface:
1. Access the Services page (Configuration tab > Voice Over IP menu > Services >
General Parameters).
Figure 17-9: Web Interface - General Parameters - Reject Code
2. Configure 'Reject Code' using the table below as reference, and then click Submit.
 To configure Reject Code using the Configuration File:
• Use the table below as reference.
Table 17-8: Reject Code Parameter
Parameter Description
Reject Code
[voip/services/reject_code]
Configures the reject code that the phone sends when the
Reject softkey is pressed or while DND is activated.
Valid values are:
[CODE_603]
[CODE_486]