400HD Series IP Phones
Administrator's Manual 276 Document #: LTRT-11950
The figure below shows Call Forwarding configuration and status in BroadSoft's
BroadWorks.
Figure A-2: Configuring Call Forwarding using BroadSoft's BroadWorks
Note: The 'Forward No Reply' timeout can be configured as 'number of rings' rather than
as 'seconds' if the BroadSoft Feature Key is enabled (by configuring the cfg file
parameter 'voip/line/0/call_forward/timeout_mode' to RINGS_COUNT instead of to the
default SECONDS). For example, if the BroadSoft Feature Key is enabled and
'voip/line/0/call_forward/timeout_mode' is configured to RINGS_COUNT, the phone will
by default ring 2r (2 rings) before the call is forwarded. The setting can be changed
according to user preference to 4r (4 rings), for example. The feature allows compliance
with BroadSoft's Feature Key Synchronization method.
For detailed information, see related BroadSoft documention.
To Next Page
Loading...
