AudioCodes 420HD - 50 Debugging Using Packet Recording Parameters; Figure 50-1: Web Interface - Recording

Administrator's Manual 50. Debugging using Packet Recording Parameters
Version 2.2.8 263 400HD Series IP Phones
50 Debugging using Packet Recording
Parameters
Packet recording parameters allow you to debug voice activity on the phone, using the Web
interface or configuration file.
 To debug using the Web interface:
1. Access the Recording page (Status & Diagnostics tab > Diagnostics menu >
Recording).
Figure 50-1: Web Interface – Recording
2. Configure the packet recording parameters using the table below as reference, and
then click Submit.
 To debug using the configuration file:
• Use the table below as reference.
Table 50-1: Recording Parameters
Parameter Description
Remote IP Address or Host Name
[voip/packet_recording/remote_ip]
The IP address (in dotted-decimal
notation) of the remote computer to
which the recorded packets are sent.
The recorded packets should be
captured by a network sniffer (such as
Wireshark).
The default value is 0.0.0.0.
Remote Port
[voip/packet_recording/remote_port]
Defines the UDP port of the remote
computer to which the recorded
packets are sent.
The valid range is 1024 to 65535. The
default value is 50000.
Enable DSP Recording
[voip/packet_recording/enabled]
Activates the packet recording
mechanism.
 [0] Disable (default)
 [1] Enable