400HD Series IP Phones
Administrator's Manual 214 Document #: LTRT-11950
32.1.1 Configuring EAP-MD5 Mode
This section shows how to configure EAP-MD5 mode for 802.1x using the phone's LCD.
To configure EAP-MD5 mode for 802.1x using the phone's LCD:
1. Navigate to the EAP-MD5 option and then press Select and Edit:
2. Enter the following information:
• Identity: User ID
• Password: MD5 password (optional)
3. Press the Save softkey; a message appears notifying you that the phone will restart.
4. Press Apply.
32.1.2 Configuring EAP-TLS Mode
This section shows how to configure EAP-TLS mode for 802.1x using the phone's LCD.
To configure EAP-TLS mode for 802.1x using the phone's LCD:
1. Navigate to the EAP-TLS option and press Select
2. Press the Save softkey; a message appears notifying you that the phone will restart.
3. Press Apply.
32.2 Configuring 802.1x Using Web and Configuration File
This section shows how to configure 802.1x using the Web interface or configuration file.
32.2.1 Configuring EAP MD5 Mode
This section shows how to configure 802.1x settings for EAP-MD5 using the Web interface.
To configure 802.1x settings for EAP-MD5 using the Web interface:
1. Access the 802.1X Settings page (Configuration > Network Connections > 802.1X
Settings) and select MD5 as 'EAP Type'.
Figure 32-1: Web Interface –801.1X Settings - EAP-MD5
2. Configure the 802.1x settings according to the parameters in the table below, and then
click Submit.
To Next Page
Loading...
