400HD Series IP Phones
Administrator's Manual 136 Document #: LTRT-11950
22.2 Using the Web Interface and Configuration File
This section shows how to configure an extension line (SIP account) using the Web interface
and Configuration File.
Note: The Web interface page of the 440HD / 430HD phone are shown here. The Web
pages of the 420HD / 405 phones are identical, except that on the 420HD/405 phones:
• 'Line Label' is displayed instead of 'Line Mode'
• two lines can be configured instead of six as on the 430HD/440HD phones
To configure an extension line (SIP account) using the Web interface:
1. Access the Line Settings page (Configuration tab > Voice Over IP menu > Line
Settings).
Figure 22-1: Web Interface - Line Settings
2. Configure the Line Settings using the table below as reference, and then click Submit.
To configure an extension line (SIP account) using the Configuration File:
• Use the table below as reference.
Table 22-1: Line Parameters
Parameter Description
Note: The value placeholder %d refers to the line number.
Line Activate
[voip/line/%d/enabled]
Activates or deactivates the line. See also Section. 26.2.1.1.
[0] = Disabled (this is the default for the second line and
higher in the Configuration File)
[1] = Enabled (this is the default for the first line
voip/line/0/ in the Configuration File).
Line User ID
[voip/line/%d/id]
Lines VoIP user's ID for identification to initiate and accept
calls.
The user's ID can be up to 30 characters.
Line Display Name
[voip/line/%d/description]
Arbitrary name to intuitively identify the line and that is
displayed to remote parties as your caller ID.
To Next Page
Loading...
