Administrator's Manual 18. Configuring Dialing
Version 2.2.8 109 400HD Series IP Phones
18 Configuring Dialing
Dialing parameters can be configured using the Web interface or Configuration File.
18.1 Configuring General Dialing Parameters
General dialing parameters can be configured using the Web interface or Configuration File.
To configure dialing using the Web interface:
1. Access the Dialing page (Configuration tab > Voice Over IP menu > Dialing).
Figure 18-1: Web Interface Dialing
2. Configure the parameters using the table below as reference, and then click Submit.
To configure dialing using the Configuration File:
• Use the table below as reference.
Table 18-1: Dialing Parameters
Parameter Description
Dialing Timeout
[voip/dialing/timeout]
The duration (in seconds) of allowed inactivity between
dialled digits. When you work with a proxy, the number you
have dialled before the dialing process has timed out is
sent to the proxy as the user ID to be called. This is useful
for calling a remote party without creating a speed dial
entry (assuming the remote party is registered with the
proxy). Range is 0 to 10. Default = 5.
Phone Number Length
[voip/dialing/phone_number_max_size]
The maximum length of shortcut numbers that you can
enter and the maximum number of digits that you can dial
Range is 3 to 32. Default = 32.
Enable Dialing Complete Key
[voip/dialing/dial_complete_key/enabled]
Enables the feature for defining a key to indicate that
dialing has completed. Pressing the Dialing Complete key
(defined below) forces the phone to make a call to the
dialled digits even if there is no match in the dial plan or
digit map.
[0] Disable
[1] Enable (default)
Note: This parameter is available only if the parameter
'voip/dialing/dial_complete_key/enabled' is set to
.
Dialing Complete Key
[voip/dialing/dial_complete_key/key]
Defines the Dialing Complete key. The valid value is a
single character. The default value is the pound (#) key.
To Next Page
Loading...
