AudioCodes 420HD - D Deploying Audiocodes IP Phones - Use Case; Preparing Configuration (Cfg) Files for the Enterprise Customer; Saving the Phones Default Configuration to File

Administrator's Manual D. Deploying AudioCodes IP Phones - Use Case
Version 2.2.8 313 400HD Series IP Phones
D Deploying AudioCodes IP Phones - Use
Case
In a typical scenario, the ISP/integrator:
1. Connects an out-of-the-box phone to the LAN and power supply and manually
configures Static IP address using the phone's LCD (MENU button > Administration >
Network Settings > LAN Connection Type).
2. Accesses the phone using the Web interface and prepares configuration files for the
enterprise customer (see Section C.1 below).
3. Places the configuration files on the enterprise customer's HTTP server and configures
DHCP Server Option 160 to point to the location (see Section C.2 below).
D.1 Preparing Configuration (cfg) Files for the Enterprise
Customer
This section shows how to prepare configuration files for the enterprise customer.
To prepare configuration files for the enterprise customer:
1. Save the phone's default configuration to file (see Section C.1.1)
2. Prepare a global.cfg configuration file (see Section C.1.2)
3. Generate private.cfg configuration files (see Section C.1.3)
D.1.1 Saving the Phone's Default Configuration to File
This section shows how to save an out-of-the box phone's default (factory) configuration to
file. This will be the baseline on which to prepare a global.cfg configuration file afterwards.
 To save a phone's default configuration to a file:
1. Open a Web browser and connect to the phone's Web interface using
http://<phone's IP address>
2. In the Web interface home page (System Information), make sure the phone is
running the latest firmware version. If not, obtain a new firmware file from
AudioCodes and load it to the phone using the Web interface's Firmware Upgrade
page (Management tab > Manual Update > Firmware Upgrade).
3. In the Web interface's Restore Defaults page, restore the default configuration
(Management tab > Administration > Restore Defaults) in case the default
configuration was modified.
4. In the Web interface's Configuration File page, save the default configuration to a
file (Management tab > Manual Update > Configuration File).