AudioCodes 420HD - Configuring Auto Redial; Figure 18-2: Automatic Redial on Busy; Table 18-2: Automatic Redial on Busy Parameters

Administrator's Manual 18. Configuring Dialing
Version 2.2.8 111 400HD Series IP Phones
18.2 Configuring Auto Redial
The administrator is responsible for enabling/disabling the auto-redial feature. If enabled and
a called party is unavailable because they're busy (for example), the caller's phone's LCD
prompts Extension Busy. Activate auto redial on busy?
If the caller then activates auto-redial by pressing Yes, the busy extension is automatically
redialed every n seconds.
The administrator is also responsible for configuring this frequency.
 To configure auto redial using the Web interface:
1. In the Dialing page, scroll down until the Automatic Redial On Busy section (VoIP >
Dialing > Automatic Redial On Busy).
Figure 18-2: Automatic Redial On Busy
2. Configure the parameters using the table below as reference, and then click Submit.
 To configure dialing using the Configuration File:
• Use the table below as reference.
Table 18-2: Automatic Redial On Busy Parameters
Parameter Description
Activate
[voip/dialing/automatic_redial_on_busy
/enabled]
Allows the administrator disable/enable the feature.
[0]=Disabled
[1]=Enabled
Default: 0
Timeout
[voip/dialing/automatic_redial_on_busy
/retry_timer]
Visible only if the feature is enabled. Range: 3-120.
Default: 30. If the feature is activated and the timer lapses,
an outgoing call to the busy destination is established. If
the feature is activated, a countdown screen is displayed:
Dialing <ext> within <x>s (Line <n>) The screen shows
the timer, the remote extension and the line number.