AudioCodes 420HD - 20 Configuring Media Settings; Configuring Media Streaming; Table 20-1: Media Streaming Parameters

Administrator's Manual 20. Configuring Media Settings
Version 2.2.8 125 400HD Series IP Phones
20 Configuring Media Settings
This section shows how to configure media settings.
20.1 Configuring Media Streaming
The Configuring Media Streaming feature can be configured using the Configuration File.
Configure the parameters using the table below as reference.
Table 20-1: Media Streaming Parameters
Parameter Description
[voip/media/rtp_mute_on_hold] Mute sending RTP packets to remote in HOLD state.
 [0] - Disabled. RTP packets are sent to remote end
when in HOLD state.
 [1] - Enabled (default). RTP packets are not sent to
remote end when in HOLD state.
[voip/media/allow_multiple_rtp]
Defines whether to allow multiple RTP streamsfrom
different remote ends to be played toward the phone in
a single call.
 [0] Disable (default)

[1]
Enable
[voip/media/ignore_rfc_2833_packets]
Defines whether to ignore playing DTMF when
RFC2833 arrives from the network.
 [0] Disable

[1]
Enable (default)
[voip/media/broken_connection_detection] If enabled an active call will be automatically
disconnected if no RTP packet is received within
pre-defined time.
 [0] Disable (default)

[1]
Enable
[voip/media/broken_connection_timeout] If no RTP packet arrives for an active call within this
timeout (in seconds), the connection will be considered
broken and the call will be disconnected. Default: 10.