AudioCodes 420HD - Transferring a Call

400HD Series IP Phones
Administrator's Manual 80 Document #: LTRT-11950
14.2 Configuring Partial DHCP
Partial DHCP can be configured with the following parameters:
Table 14-2: Partial DHCP Parameters
Parameter Description
Partial DHCP
network/lan/dhcp
This subsection defines the parameters to
configure if 'lan_type' is configured to DHCP.
Domain Name - Manual
[network/lan/dhcp/domain_name/enabled]
Enables setting the domain name manually.
 [0] Disable (default)
 [1] Enable
Note: If enabled,
network/lan/fixed_ip/domain_name
must be set.
IP Address - Manual
[network/lan/dhcp/ip_address/enabled]
Enables setting the IP address manually.
 [0] Disable
 [1] Enable (default)
Note: If enabled,
network/lan/fixed_ip/ip_address
must be set.
Subnet Mask - Manual
[network/lan/dhcp/netmask/enabled]
Enables setting the network mask manually.
 [0] Disable
 [1] Enable (default)
Note: If enabled, network/lan/fixed_ip/netmask
must be set.
[network/lan/dhcp/gateway/enabled]
Enables setting the default gateway manually.
 [0] Disable
 [1] Enable (default)
Note: If enabled, network/lan/fixed_ip/gateway
must be set.
Primary DNS - Manual
[network/lan/dhcp/primary_dns/enabled]
Enables setting the primary DNS manually.
 [0] Disable (default)
 [1] Enable
Note: If enabled,
network/lan/fixed_ip/primary_dns must be set.
Secondary DNS - Manual
network/lan/dhcp/secondary_dns/enabled
Enables setting the secondary DNS manually.
 [0] Disable (default)
 [1] Enable
Note:If enabled,
network/lan/fixed_ip/secondary_dns must be
set.