AudioCodes 420HD - Page 113

Administrator's Manual 18. Configuring Dialing
Version 2.2.8 113 400HD Series IP Phones
Parameter Description
Secondary Dial Tone
[voip/dialing/secondary_dial_tone/enabled]
Enables the secondary dial tone.
 [0] Disable (default) - Phone doesn't use
secondary dial tone.
 [1] Enable - Phone plays secondary dial tone if
the secondary dial tone key is pressed (first
digit).
Secondary Dial Tone Key
[voip/dialing/secondary_dial_tone/key_sequence]
Defines the secondary dial tone is played if this is
the first key pressed.
Range:0 to 9. Default: 9.
Note: This parameter is available only if the
parameter '
voip/dialing/secondary_dial_tone/enabled'
is set to 1.
Out of Service Behavior
[voip/services/out_of_service_behavior]
Determines whether a reorder tone is played
instead of a dial tone if you configured a Registrar
IP address and the registration failed.
 [NONE] No Tone

[REORDER_TONE]
Reorder Tone (default)
Stutter Tone Duration
[voip/services/msg_waiting/stutter_tone_duration]
Defines the duration for which a stutter tone is
played when you have unheard messages.
Range:1000 to 60000.
Default: 2500.
Automatic Disconnect
[voip/dialing/automatic_disconnect]
Determines whether the phone automatically goes
idle (i.e. on-hook) when the last remaining call is
disconnected. This is only relevant when the
speaker or headset is used.
 [0] Disable
 [1] Enable (default)