Version 2.6 103 May 1
MP-202 Telephone Adapter 10. VLAN and Bridge Settings
Select one of the following options from the 'IP Address Distribution' combo box:
Table 10-2: IP Address Distribution Parameters
Parameter Description
DHCP Server Start IP Address The first IP address that may be assigned to a LAN host.
Since the device's default IP address is 192.168.2.1, this address must be
192.168.2.2 or greater.
End IP Address The last IP address in the range that can be used to automatically assign
IP addresses to LAN hosts.
Subnet Mask A mask used to determine to what subnet an IP address belongs. An
example of a subnet mask value is 255.255.0.0.
Lease Time In Minutes Each device will be assigned an IP address by the DHCP server for a this
amount of time, when it connects to the network. When the lease expires
the server will determine if the computer has disconnected from the
network. If it has, the server may reassign this IP address to a newly-
connected computer. This feature ensures that IP addresses that are not
in use will become available for other computers on the network.
Provide Host Name If Not
Specified by Client
If the DHCP client does not have a host name, the device will
automatically assign one for him.
Figure 10-6: IP Address Distribution - DHCP Server
Table 10-3: DHCP Relay
DHCP Relay Your device can act as a DHCP relay in case you would like to
dynamically assign IP addresses from a DHCP server other than your
Telephone Adapter's DHCP server. Note that when selecting this option
you must also change the device's WAN to work in routing mode. For
detailed information, refer to Section 10.28.2.
To Next Page
Loading...
Need help?
General
