Version 2.6 147 May 1
MP-202 Telephone Adapter 12. Security
4. Leave the Source Ports combo-box at its default 'Any'. In the drop-down list
'Destination Ports', select 'Single'; the screen refreshes again, providing an additional
field in which you should enter '2222' as the destination port.
Figure 12-15: Edit Service Server Ports
5. Click 'OK' to save the settings.
6. In the screen 'Edit Service', click the link 'New Opened Ports'; the screen 'Edit Service
Opened Ports' opens (refer to the figure).
Figure 12-16: Edit Service Opened Ports
7. Similar to the trigger ports screen, select UDP as the protocol, leave the source port at
'Any', and enter a 3333 as the single destination port (refer to the figure).
Figure 12-17: Edit Service Opened Ports
To Next Page
Loading...
