Name: AudioCodes MP-202
Brand: AudioCodes
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Version 2.6 173 May 1

MP-202 Telephone Adapter 13. Advanced Settings

2. Under the screen section 'Ping (ICMP Echo)', enter the IP address or URL to be

tested in the 'Destination' field.

3. Enter the number of pings you would like to perform.

4. Press the 'Go' button.

5. In a few seconds, diagnostic statistics are displayed (refer to the figure below). If no

new information is displayed, press the 'Refresh' button.

Figure 13-12: Advanced - Diagnostics - Statistics

13.6.2 Performing a Traceroute

¾ To perform a traceroute:

1. Click the 'Diagnostics' icon from the 'Advanced' screen in the Web-based

Management; the 'Diagnostics' screen is displayed.

2. Under the screen section 'Traceroute', enter the IP address or URL to be tested in the

'Destination' field.

3. Press the button 'Go'; a traceroute commences, constantly refreshing the screen (refer

to the figure above).

4. To stop the trace and view the results, press 'Cancel'.

Other manuals for AudioCodes MP-202

Questions and Answers:

Need help?

Do you have a question about the AudioCodes MP-202 and is the answer not in the manual?

General