EasyManuals Logo

AudioCodes MP-202 User Manual

AudioCodes MP-202
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Version 2.6 57 May 1
MP-202 Telephone Adapter 7. Making VoIP Calls
7 Making VoIP Calls
Users connected to the MP-202 can place calls, put calls on hold, transfer calls and
manage 3-way conferences. The following describes how to perform these operations.
7.1 Placing a Call
¾ To place a call, take these steps:
1. Pick up the phone.
2. Make sure that you can hear a dial tone
3. Dial the remote party's number or pre-configured speed dial number.
7.2 Answering a Waiting Call
¾ To answer a waiting call when 'Flash only' is configured (refer to
''Configuring Dialing Parameters'' on page 39):
1. When you hear a call waiting tone (during a call), press 'Flash' on the phone; this puts
the active call on hold and switches to the waiting call.
2. To return to the original call, press Flash again. You can toggle from one party to
another as much as you like by pressing Flash.
¾ To answer a waiting call when 'Flash + digits sequence' is
configured (refer to ''Configuring Dialing Parameters'' on page 39):
1. When you hear the call waiting tone (during a call), press the 'Flash' key on the phone
and then the '1' key; this puts the original call on hold and switches to the waiting call.
2. To return to the original call, press Flash+1 again. You can toggle from one party to
another as much as you like by pressing Flash+1.
7.3 Putting a Call on Hold
¾ To place the remote party on hold when 'Flash only' is configured
(refer to ''Configuring Dialing Parameters'' on page 39):
1. During a call, press 'Flash' on the phone; the phone plays a dial tone. At this point you
can initiate a second call by dialing another party's number.
Note: If you press 'Flash' again before the other party answers, you'll revert to the
original call. If, however, the other party answers and you press 'Flash', a 3-
way conference is established.

Table of Contents

Other manuals for AudioCodes MP-202

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MP-202 and is the answer not in the manual?

AudioCodes MP-202 Specifications

General IconGeneral
ModelMP-202
CategoryAdapter
Ports2 FXS ports
Protocol SupportSIP, H.323
Weight0.5 kg
Operating Temperature0°C to 40°C
Storage Temperature-20°C to 70°C
Humidity10% to 90% non-condensing
Network Interface10/100Base-T Ethernet
Voice CodecsG.711, G.729, G.723.1, G.726
SecurityHTTPS, TLS, SRTP
ManagementWeb-based, SNMP
Power Supply12V DC

Related product manuals