Version 2.6 175 May 1
MP-202 Telephone Adapter 13. Advanced Settings
¾ To select your present location:
1. Click the icon 'Regional Settings' in the 'Advanced' screen of the Web-based
Management; the 'Regional Settings' screen opens (refer to the figure below).
2. Select the country from the drop-down menu. If your current location is not in the list,
contact your Service Provider.
Figure 13-14: Regional Settings
13.9 System Settings
The screen 'System Settings' allows you to configure various system and management
parameters.
Use the screen section 'System Settings' to configure:
The Telephone Adapter's host name. The host name is the Telephone Adapter's URL
address.
Your network's local domain.
Use the screen section 'MP-202 Management Console' to configure:
Automatic Refresh of System Monitoring Web Pages - select this check-box to enable
the automatic refresh of system monitoring web pages.
Warn User Before Network Conguration Changes - select this check-box to activate
user warnings before network configuration changes take effect.
Session Lifetime - the duration of idle time (in seconds) in which the WBM session will
remain active. When this duration times out, the user will have to re-login.
Language - select a different language for the WBM interface.
Use the link 'Remote Administration' to access the MP-202's remote administration screen,
from where you can selectively enable services that grant remote access to the MP-202.
Use the screen section 'Management Application Ports' to configure:
Primary/secondary HTTP ports
Primary/secondary HTTPS ports
Primary/secondary Telnet ports
Secure Telnet over SSL ports
To Next Page
Loading...
