MP-202 Telephone Adapter 78 Document #: LTRT-50605
User's Manual
¾ To configure the WAN Ethernet connection:
Click on the 'Settings' button at the bottom-right of the connection's Properties screen;
the screen 'Configure WAN Ethernet' opens:
Figure 9-2: WAN Ethernet Configuration
9.1.1 General
The top part of the screen 'Configure WAN Ethernet' displays general communication
parameters. It is recommended not to change the default values in this screen unless you
are familiar with the networking concepts they represent. Since your Telephone Adapter is
configured to operate with the default values, no parameter modification is necessary. You
can configure the following general connection settings:
To Next Page
Loading...
