Version 2.6 55 May 1
MP-202 Telephone Adapter 6. Connecting the MP-202 to a VoIP Service Provider
6 Connecting the MP-202 to a VoIP Service
Provider
Using the MP-202's VoIP capabilities, it is possible to connect to a remote SIP server in
order to conduct worldwide phone calls.
The following section describes how to place a worldwide phone call utilizing the MP-202's
VoIP capabilities over a SIP server. Verify that your Telephone Adapter and telephone are
correctly connected and that your WAN connection is up.
6.1 Opening a SIP Account
Before you can connect to a SIP server, it is necessary that you obtain a SIP account. The
following section describes how to open a free worldwide dialing SIP account. You can also
obtain a paid SIP account.
¾ To open a free worldwide dialing SIP account on the Pulver.com
Free World Dialup service:
Browse to ''http://www.pulver.com/fwd'' http://www.pulver.com/fwd and open a new
account.
6.2 Configuring VoIP Parameters
Note: This section describes the minimal set of changes required to connect to a
VoIP Service Provider. Other configuration changes might be required to
connect to some Service Providers.
¾ To configure VoIP parameters:
1. Click the icon ‘Voice Over IP’ on the toolbar on the left side of the page; the ‘Voice
Over IP’ configuration screen opens.
2. Click tab ‘Line Settings’. If you only have a single number, disable line 2 by
unchecking the ‘2’ checkbox and click ‘Apply’.
Figure 6-1: VoIP - Line Settings
To Next Page
Loading...
