Name: AudioCodes MP-202
Brand: AudioCodes
Rating: 4 (1 reviews)

To Next Page

To Previous Page

MP-202 Telephone Adapter 110 Document #: LTRT-50605

User's Manual

4. Assign an IP address (static / DHCP) to the new interface. Configure the parameter

'Internet Protocol' to the Static IP option of 'Use the Following IP Address'; the screen

shown below opens.

Figure 10-18: Use the Following IP Address

5. Define an IP address for each device and click Apply and OK.

Changing the Routing Mode

¾ To change the routing mode:

1. (For all VOIP packets needing to be transferred within the VoIP VLAN) Open menu

Network Connections > WAN Ethernet 2 > Settings; the figure shown below opens.

Figure 10-19: Routing - Advanced

2. In the Routing drop-down list, change the mode to 'Advanced'; extended parameters

are displayed (refer to the figure below).

Figure 10-20: Routing - Advanced - Extended Parameters

3. Configure parameter 'Routing Mode' (NAT or Route). Choose 'Route' and check the

check box 'Default Route' in order to use the VoIP VLAN.

4. Configure 'Device Metric' to be the lower than the default metric (default = 3).

Other manuals for AudioCodes MP-202

Questions and Answers:

Need help?

Do you have a question about the AudioCodes MP-202 and is the answer not in the manual?

General