EasyManuals Logo

AudioCodes MP-202 User Manual

AudioCodes MP-202
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
MP-202 Telephone Adapter 158 Document #: LTRT-50605
User's Manual
NAT out failed - NAT failed for this packet.
DHCP request - OpenRG sent a DHCP request (depends on the distribution).
DHCP response - OpenRG received a DHCP response (depends on the distribution).
DHCP relay agent - a DHCP relay packet has been received (depends on the distribution).
IGMP packet - an IGMP packet has been accepted.
Multicast IGMP connection - a multicast packet has been accepted.
RIP packet - a RIP packet has been accepted.
PPTP connection - a packet inquiring whether OpenRG is ready to receive a PPTP
connection has been accepted.
Kerberos key management 1293 - security related, for future use.
Kerberos 88 - for future use.
AUTH:113 request - an outbound packet for AUTH protocol has been accepted (for
maximum security level).
Packet-Cable - for future use.
IPV6 over IPV4 - an IPv6 over IPv4 packet has been accepted.
ARP - an ARP packet has been accepted.
PPP Discover - a PPP discover packet has been accepted.
PPP Session - a PPP session packet has been accepted.
802.1Q - a 802.1Q (VLAN) packet has been accepted.
Outbound Auth1X - an outbound Auth1X packet has been accepted.
IP Version 6 - an IPv6 packet has been accepted.
OpenRG initiated traffic - all traffic that OpenRG initiates is recorded.
Maximum security enabled service - a packet has been accepted because it belongs to a
permitted service in the maximum security level.
SynCookies Protection - a SynCookies packet has been blocked.
ICMP Flood Protection - a packet has been blocked, stopping an ICMP flood.
UDP Flood Protection - a packet has been blocked, stopping a UDP flood.
Service - a packet has been accepted because of a certain service, as specified in the
event type.
Advanced Filter Rule - a packet has been accepted/blocked because of an advanced filter
rule.
Fragmented packet, header too small - a packet has been blocked because after the
defragmentation, the header was too small.
Fragmented packet, header too big - a packet has been blocked because after the
defragmentation, the header was too big.
Fragmented packet, drop all - not used.
Fragmented packet, bad align - a packet has been blocked because after the
defragmentation, the packet was badly aligned.
Fragmented packet, packet too big - a packet has been blocked because after the
defragmentation, the packet was too big.
Fragmented packet, packet exceeds - a packet has been blocked because
defragmentation found more fragments than allowed.

Table of Contents

Other manuals for AudioCodes MP-202

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MP-202 and is the answer not in the manual?

AudioCodes MP-202 Specifications

General IconGeneral
ModelMP-202
CategoryAdapter
Ports2 FXS ports
Protocol SupportSIP, H.323
Weight0.5 kg
Operating Temperature0°C to 40°C
Storage Temperature-20°C to 70°C
Humidity10% to 90% non-condensing
Network Interface10/100Base-T Ethernet
Voice CodecsG.711, G.729, G.723.1, G.726
SecurityHTTPS, TLS, SRTP
ManagementWeb-based, SNMP
Power Supply12V DC

Related product manuals