5. Troubleshooting
Code 8605: “Check ambient temperature” (Error)
Situation Solution
Ambient temperature high.
Check ambient temperature. The ambient temperature must be between 10°C (50°F)
and 4 0°C (104°F).
Code 8620: “no signal shutdown” (Info)
Situation Solution
The projector has automatically shut
down because no input signal was
detected for a c ertain period on any
of the input slots.
If this situation is not des ired s witch off the automatically shut down option in the projector
software. See installation m anual of the HDF projector.
Code 8621: “No dmx shutdown” (Info)
Situation Solution
The projector has automatically shut
down because no DMX signal was
detected for a certain period on XLR
communication port.
If this situation is not des ired s witch off the automatically shut down option in the projector
software. See installation m anual of the HDF projector.
Code 8700: “Lamp not inserted” (Error)
Situation Solution
The Lam p House is not correctly
installed.
Check if the Lamp House is properly installed. Ma ke sure that all three fixat ion sc rews
(reference 1, 2 & 3 image 5-36) of the Lamp H ouse are fastened. See installation
procedure "Lamp and lamp house", page 117 .
Damaged La mp Info module
socket s.
1. Check if the blue socket at the front of the Lamp Hous e (reference 1 image 5-11) is
not damaged. If damaged, replace the Lamp Info module. See "Lamp info m odule
replacement", page 138.
2. Check if the blue soc ket inside the Lamp House compartment (reference 2
image 5-12) is not damaged. If damaged, replace the main wire tree.
Wire unit of the Lamp Info module
socket is disc onnected from the
Power Backplane.
Reconnect the wire unit (reference 6 image 5-4 2) with the Power Distributio
n board .
Malfunction Lamp Info Module .
The projector can not read from the
installed La mp Info Module.
In c ase no other “board read errors” appears, replace the Lam p House. The Lamp Info
Module is located inside the Lamp House, behind the blue so
cket. See "Lamp and
lamp house", page 117
Malfunction internal RS485
communication line. The FCB, MCB
and CLO also reports “read er rors”.
Disconnect the board s one by one from the internal RS4 85 line until this error disappears.
Replace the board which makes this error goe s away. See chapter "Projector block
diagram", page 15, t o know which boards are using the inter
nal RS485 comm unication
line. If the pro blem remains replace the PMP.
Code 8701: “Tilt orientation invalid” (Error)
Situation Solution
The pr ojector is tilted in a position
which is n ot allowed.
Ensure that the right side (input side) of the projector doesn’t face the floor. To know the
exact tilting range see installation manual of the HDF projector.
Code 8702: “Engine not connected” (Error)
Situation Solution
One or m ore of the six data wire
units are disconnected between the
PMP board and Light Processor.
Ensure that all six wire units between the PMP board and Light Processor s atellite
boards are properly connected.
Code 8703: “Cooling startup failed” (Error)
Situation Solution
One of the projector c ooling sy stems
fails which disable the start up o f the
lamp.
Check for filthy dust filters, blocked air inlets and outlets, liquid cooling level, etc. Check
also other error/warning m ess ages. See projector no tifications.
R5905312 HDF W SERIES 24/01/2013 89
To Next Page
Loading...
