ekrPro Com
60
web guide controller EDV-No.: MD.191.01.05/1.6.x
with analog sensors Date: 23.11.2007 Page: 1/1
Contents
Section C
Operation
Table of contents
C 1 Display and operating controls C1-1
C 1.1 Control panel C1-1
C 1.2 Navigating within the system C1-2
C 1.2.1 Function keys (F-keys) C1-2
C 1.2.2 Arrow keys C1-4
C 1.2.3 Buttons C1-6
C 2 Operation C2-1
C 2.1 General information C2-1
C 2.1.1 Graphics display C2-1
C 2.2 Changing the settings during operation C2-5
C 2.2.1 Operating functions C2-5
C 2.2.2 Scan start C2-6
C 2.2.3 Gain adjustment C2-7
C 2.2.4 Changing the settings C2-7
C 2.3 Sensor positioning device C2-8
C 2.3.1 Use of FVG functionality, general C2-8
C 2.3.2 Use of FVGPro 2MK functionality C2-8
C 2.3.3 Arrow key functions and the functions of the C2-8
digital inputs
C 2.4 Material set-up C2-10
C 2.4.1 Automatic material set-up C2-11
C 2.4.2 Manual material set-up C2-11
C 2.4.3 Special procedure if an analog reflecting sensor C2-12
is connected as Sensor 3
C 2.4.4 Manual material set-up for sensors C2-12
T 62 D 1 and TW 54 C5
C 2.4.4.1 Settings for the T 62 D 1 C2-13
C 2.4.4.2 Material set-up C2-14
C 2.5 Tear-off detection C2-15
C 2.6 Oscillation C2-16
C 2.7 Pre-positioning C2-17
C 2.8 Pre-positioning to machine centre C2-18
C 2.9 Unit remote control via CAN bus C2-19
C 3 Error reports C3-1
C 4 Maintenance C4-1
C 4.1 ekrPro Com
60
controller C4-1
C 4.2 Sensors C4-1
C 4.3 Electric motor powered actuator C4-1
C 4.4 Hydraulically powered actuator C4-1
C 4.5 FVG-stepping motor C4-1
To Next Page
Loading...
Need help?
General
