Operation C 2
ekrPro Com
60
web guide controller EDV-No.: MD.191.01.05/1.6.x Chapter: C 2
with analog sensors Date: 23.11.2007 Page: 5/19
C 2.2 Changing the settings during operation
Use the membrane-keys to set up the operating functions and the
scanning modes as well as the settings and to optimise the
controller gain.
C 2.2.1 Operating functions
Proceed as follows to set up the required operating functions:
Automatic mode
Press the “AUTO“ key.
Manual positioning
Press the “MAN“ key.
Manual positioning of the actuator
1)
Press the “MAN“ key.
Use the horizontal arrow keys to carry out
positioning
Centre positioning
Press ”S-C” key
To Next Page
Loading...