Error reports C 3
ekrPro Com
60
web guide controller EDV-No.: MD.191.01.05/1.6.x Chapter: C 3
with analog sensors Date: 23.11.2007 Page: 1/4
C 3 Error reports
Errors are indicated by the error LED illuminating.
You can chose to display them or suppress them. Furthermore, the
display duration of a reported error can be varied.
These settings are made in the menu
General Setup > Special > Dev. Config..
In generally we differentiate between two types of errors:
1. To acknowledge an error
The error report must be acknowledged by pressing the
‘ENTER‘ button and then the display and the error-LED will be
extinguished.
The error report will be displayed immediately after being
acknowledged if the error has not been eliminated.
2. Self-deleting errors
The error message is deleted automatically as soon as the error
is eliminated. The error LED will be extinguished.
In general, the system error that occurred last is the
one that is displayed. Any error messages that were
displayed previously are cleared automatically.
All error reports will be displayed in full on the screen immediately
after they occur.
Example:
Actuator drawing excess current.
This error report must be acknowledged.
To Next Page
Loading...
Need help?
General
