Canon imageCLASS MF273dw - Page 557

Checking the Status and Log for Sent and Received Faxes(P. 243)
An Error Code Is Displayed(P. 575)
Is [Memory is full.] Displayed on the Oper
ation Panel?
If so, scanning of the original cannot be performed due to insucient available memory
.
Try the following:
● If there is data waiting to be printed or sent, wait until the processing is completed.
● When sending an original with many pages, divide the original and send it.
● Check the faxes received in the memory of the machine, and print or forward them as needed, and delete
any unnecessary faxes.
Viewing and Printing Faxes Saved in the Memory(P. 333)
● Change the set r
esolution to a lower resolution when scanning the original.
[Home] screen on the operation panel [Fax] [TX/RX Settings] [Resolution] Select the resolution.
Step 3: Checking the Send Status
Did You Specify a Correct Destination?
A telephone number may have been specied, or the fax number may be incorr
ect. Check that the specied
destination is correct, and send again.
Are You Sending a Fax via Optical Line
The machine conforms to analog line standards, and sending of faxes via optical line cannot be guaranteed. You
may be able to perform oper
ations via optical line, so see the following.
Cannot Send or Receive a Fax via Optical Line(P. 552)
Is the T
ype of Telephone Line Congured Correctly?
The type of telephone line may not be automatically congur
ed correctly. Congure the type of telephone line
manually.
Log in to Remote UI [Settings/Registration] [TX Settings] [Fax TX Settings] [Edit] in [Select Line
T
ype], select [Manual]
in [Line], select the type of telephone line [OK]
On the operation panel, select [Menu] in the [Home] screen, and then select [Function Settings] to congur
e the
settings.
[Select Line Type](P. 438)
* If you do not kno
w the type of telephone line, contact your telephone company.
Did You Specify an Overseas Destination?
If so, you may not have been able to connect correctly to the destination. After entering the international access
number or country code, enter the wait time (pause) and lo
wer the communication start speed before sending
the fax.
Cannot Send a Fax to an International Destination(P. 553)
Is the Send Destination Ready to Receive a Fax?
The power of the receiving device may not be turned on, or the RX Mode may not be congur
ed correctly. Have
the other party check these.
Troubleshooting
548