Canon imageCLASS MF273dw - Page 77

When the machine is connected to the wireless LAN, [ ] appears on the [Home] screen and screen of
each function.
7
Wait a few minutes.
➠ By default, an IP addr
ess is set automatically.
To use a specic IP address, set this manually.
Setting IPv4 Addresses(P. 71)
Setting IPv6 Addresses(P. 75)
If an Error Message Appears during Operation and a Connection Cannot Be Established
● Pr
ess [Close], check the information of the wireless LAN router to which you want to connect, and repeat the
procedure starting from Step 2.
5 Lines LCD Model
Required Preparations
● Pr
epare the information of the wireless LAN router to which you want to connect, and keep it close by.
Wireless LAN Router Information Required for Connection(P. 56)
● When connecting to a wir
eless LAN router supporting WPA-EAP or WPA2-EAP for the security standard, set
IEEE 802.1X.
Using IEEE 802.1X(P. 313)
1
On the operation panel, select [Wireless LAN Set.] in the [Home] screenand press .
[Home] Screen(P. 113)
➠ The [Select Network] screen is displayed.
● If the login screen appears, enter the System Manager ID and PIN, and then press . System
Manager ID and PIN(P
. 5)
● If the message [Enable the wireless LAN?] appears, select [Yes] and press
.
● If the message [Cannot nd the access point.] appears, select [Close] and pr
ess
.
2
Select [Other Connections] and press .
3
Select [Manually Enter Network Name] and press .
➠ The SSID input scr
een is displayed.
4
Enter the SSID, select [<Apply>], and press
.
➠ The [Security Settings] scr
een is displayed.
Setting Up
68