Setting Item Description, Instructions
Interface
Setup
NetWare
Frame Type Specify the frame type to use.
Print Service Choose the print service.
AppleTalk Specify whether to use the AppleTalk protocol. To apply your
changes, choose Register Setting.
Ethernet
Driver
Auto Detect Specify the communication method. To apply your changes,
choose Register Setting.
Choose On for automatic configuration of the LAN communi-
cation protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Comm.Mode Choose the LAN communication method.
Ethernet Type Choose the LAN transfer rate.
Spanning Tree Choose whether spanning-tree packets are supported over
the LAN.
MAC Address Indicates the MAC address.
Interface Print Print interface settings information.
Return Defaults Choose OK to restore Interface Setup settings to the default
values.
System
Setup
Sleep Timer Specify the period before the printer enters sleep mode.
Shut Down Timer Sets the time until the printer turns off automatically. If no op-
erations are performed on the printer for the duration of the
time set in Shut Down Timer after entering Sleep mode, the
printer automatically turns off.
Buzzer Choose On for the buzzer to sound once for warnings and
three times for errors.
Contrast Adj. Adjust the Display Screen contrast level.
Date &
Time
Date Set the current date.
Time Set the current time. Available only if the Date setting is
specified.
Date Format Specify the date format.
Language Specify the language used on the Display Screen.
Time Zone Specify the time zone. Time zone options indicate a main city
in this time zone and the difference from Greenwich Mean
Time.
Length Unit Choose the display unit for length. Change the unit displayed
for the remaining amount of roll paper, Tot.Print Area, and
so on.
Detect Mismatch Specify printing behavior if the type and size of paper speci-
fied in the printer menu does not match the type and size in
the printer driver.
Choose Pause to have printing paused under these circum-
stances. Choose Warning to continue printing after notifica-
tion. Choose None to continue printing without notification.
Choose Hold Job to store jobs with mismatched types and
sizes of paper on the printer hard disk, in a print queue await-
ing processing. (See "Using the Printer Hard
Disk.") ➔ P.670
Paper
Size Ba-
sis
Sht Selection 1 If sheet size detection is activated, choose whether ISO A3+
or 13"x19"(Super B) is applied when a sheet of an inter-
mediate size is detected.
Sht Selection 2 If sheet size detection is activated, choose whether ISO B1
or 28"x40" (ANSI F) is applied when a sheet of an intermedi-
ate size is detected.
iPF8400S
Menu Settings
User's Guide
Control Panel Printer Menu
597
To Next Page
Loading...
