Canon MX360 Seires - Page 40

Note
If the machine will not switch to fax reception, press the
FAX
button, then the
Color
or
Black
button to receive the fax.
To receive a fax without picking up the handset, set Manual/auto switch to ON. RX start time
allows you to specify the number of seconds until the machine switches to fax reception.
If you have subscribed to Duplex Ringing service in Hong Kong, the telephone will ring a
specified number of times when there is an incoming call with a fax distinctive ring pattern.
Then, the machine will switch to fax reception automatically without the handset being picked
up.
The number of times to ring the telephone until switching to fax reception can be changed.
For Details, refer to the on-screen manual:
Advanced Guide
.
Other options
Set the machine to enable you to initiate fax reception from a connected telephone (remote
reception).
See
Remote Reception
.
Note
When the answering machine is connected to the machine
If the answering machine is set to the answering mode, set User-friendly RX to ON. If the call is a
fax, the machine will receive the fax automatically.
If the answering mode is turned off on the answering machine, follow step (1) above.
If Manual/auto switch is set to ON, set RX start time to longer than the time before the answering
machine starts playing the answering message.
After making this setting, we recommend that you call the answering machine using a mobile
phone, etc. to confirm that messages are recorded successfully in the answering machine.
Set your answering machine to answering mode and adjust it as follows:
- The entire message should be no longer than 15 seconds.
- In the message, tell your callers how to send a fax.
When the call is a voice call:
The telephone will ring when a call incomes.
(1)
Pick up the handset, and talk on the telephone.
Note
If the machine unexpectedly switches to fax reception during telephone calls, set User-friendly
RX to OFF.
See Selecting a Receive Mode .
If Manual/auto switch is set to ON, you must answer an incoming call by picking up the
handset within the time specified in RX start time. Otherwise the machine will switch to fax
reception.
When Fax only mode is selected:
When the call is a fax.
The machine will receive the fax automatically.
Seite 40 von 922 SeitenReceiving Faxes