Advanced Guide
>
Faxing
>
Registering Recipients for Speed Dialing
>
Using Speed Dial Utility
> Starting
Up Speed Dial Utility
F040
Starting Up Speed Dial Utility
Before starting up Speed Dial Utility, confirm the following:
The necessary application software (MP Drivers and Speed Dial Utility)
is installed.
If the application software (MP Drivers and Speed Dial Utility) is not yet installed, insert the
Setup CD
-ROM
into the computer's disc drive, then perform Custom Install and select MP Drivers and
Speed Dial Utility.
The machine is connected to a computer correctly.
Make sure that the machine is connected to the computer correctly.
Do not plug in or unplug the USB cable when saving registered information on the computer, or
when the computer is in sleep or standby mode.
For MX410 series, if you use Speed Dial Utility via a network connection, make sure that all the
required settings have been specified.
Follow the procedure below to start up Speed Dial Utility.
1.
Make sure that the machine is turned on.
2.
Click Start and select All programs, Canon Utilities, Speed Dial Utility, and then
Speed Dial Utility.
Speed Dial Utility starts up.
Note
You can also start up the Speed Dial Utility by clicking Speed Dial Settings from Help &
Settings on Solution Menu EX.
Page top
Seite 664 von 922 SeitenStarting Up Speed Dial Utility
To Next Page
Loading...
