Advanced Guide
>
Faxing
>
Receiving Faxes > Changing the Print Settings
F018
Changing the Print Settings
This machine prints received faxes to paper loaded in the machine beforehand. You can use the
Operation Panel to change the paper settings for printing faxes. Make sure that the settings are
appropriate for the loaded paper.
Important
If paper other than A4, Letter-, Legal-, or 8.5 x 14 inches sized paper is loaded, the received faxes
are stored in machine's memory and Change the paper A4/LTR/Legal Plain paper is displayed on
the LCD. In this case, replace the loaded paper with A4, Letter-, Legal-, or 8.5 x 14 inches sized
paper, then press the
OK
button.
You can also press the
Stop
button to close the message and print the stored documents in
machine's memory later.
Deleting a Document in Machine's Memory
Note
If the sender sends a document that is larger than Letter-size or Legal-size, such as 11 x 17 inches,
the sender's machine may send the fax automatically reduced in size or divided, or send only a part
of the original.
1.
Make sure that the machine is turned on.
2.
Press the
FAX
button.
The Fax standby screen is displayed.
3.
Press the
Settings
button.
4.
Use the button to select A4, Letter, LTR, or Legal, then press the
OK
button.
Note
The * (asterisk) on the LCD indicates the current setting.
Some of page sizes are not available depending on the country or region of purchase.
5.
Make sure that Plain paper is selected, then press the
OK
button.
Note
If any media type other than Plain paper is selected, select Plain paper using the
button,
then press the
OK
button.
The LCD returns to the Fax standby screen.
Page top
Seite 640 von 922 SeitenChanging the Print Settings
To Next Page
Loading...
