Canon MX360 Seires - Computer Stops Operating During Scanning

Advanced Guide
>
Troubleshooting
>
Problems with Scanning
> Computer Stops Operating during
Scanning
S910
Computer Stops Operating during Scanning
Check 1: Restart the computer, reduce the output resolution in ScanGear
(scanner driver) and scan again.
Output Settings
Check 2: Delete unnecessary files to obtain sufficient free hard disk space,
then scan again.
Error message may appear if there is not enough hard disk space to scan and save, when the image
size is too large (such as when scanning a large document at high resolution).
Check 3: For Location of Temporary Files in MP Navigator EX, specify a
folder on a drive with sufficient free space.
General Tab
Check 4: Multiple devices may be connected to USB ports.
Disconnect other devices.
Page top
Seite 865 von 922 SeitenComputer Stops Operating during Scanning