Canon MX360 Seires - Scanning in Basic Mode

Advanced Guide
>
Scanning
>
Scanning with Other Application Software
>
Scanning with Advanced
Settings Using ScanGear (Scanner Driver) > Scanning in Basic Mode
S203
Scanning in Basic Mode
Use the Basic Mode tab to scan easily by following the on-screen steps.
See "
Scanning Multiple Documents at One Time with ScanGear (Scanner Driver)
" to scan multiple
documents at one time from the Platen.
When scanning from the ADF (Auto Document Feeder), documents are scanned without preview.
Important
The following types of documents may not be cropped correctly when scanning from the Platen. In
that case, click
(Thumbnail) on the Toolbar to switch to whole image view and scan.
- Photos that have a whitish border
- Documents printed on white paper, hand-written text, business cards, etc.
- Thin documents
- Thick documents
The following types of documents cannot be cropped correctly when scanning from the Platen.
- Documents smaller than 1.2 inches (3 cm) square
- Photos that have been cut to various shapes
1.
Place the document on the Platen or ADF, then start ScanGear (scanner driver).
Placing Documents
Starting ScanGear (Scanner Driver)
2.
Set Select Source according to the document placed on the Platen.
Important
Some applications do not support continuous scanning from the ADF. For details, refer to the
application's manual.
Note
To scan magazines containing many color photos, select Magazine(Color).
3.
Click Preview.
Seite 545 von 922 SeitenScanning in Basic Mode