Canon MX360 Seires - Error Message Appears on a Pictbridge Compliant Device

Advanced Guide
>
Troubleshooting
> Error Message Appears on a PictBridge Compliant Device
U334
Error Message Appears on a PictBridge Compliant Device
The following are the possible errors that may occur when printing directly from a PictBridge compliant
device and the countermeasures to clear them.
Note
This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The
error messages and operations may vary depending on the device you are using. For errors on non
-Canon PictBridge compliant devices, check the error message on the LCD and take the
appropriate action to clear the error. For details, see An Error Message Is Displayed on the LCD
.
For the errors indicated on the PictBridge compliant device and their solution, also refer to the
instruction manual of the device. For other troubles on the device, contact the manufacturer.
Error Message on the PictBridge Compliant
Device
Action
"Printer in use" If the machine is printing from the computer or
warming up, wait until the job ends.
When it is ready, the machine starts printing
automatically.
"No paper" Load paper on the Rear Tray, and select
Continue* in the display on your PictBridge
compliant device.
* To resume printing, you can also press the
OK
button on the machine instead of selecting
Continue on the device.
"Paper Error"
The Paper Output Tray is closed.
Open the Paper Output Tray, then press the
OK
button on the machine.
"Paper jam"
Select Stop in the display on your PictBridge
compliant device to stop printing.
Remove the jammed paper, load new paper,
press the
OK
button on the machine, and try
printing again.
"Printer cover open"
Close the Scanning Unit (Cover) on the machine.
"No print head" The FINE Cartridge may not be installed properly
or the Cartridge may not be compatible with this
machine.
Open the Scanning Unit (Cover) and install the
appropriate FINE Cartridge. After that, push the Ink
Cartridge Locking Cover until it clicks into place,
then close the Scanning Unit (Cover).
See Check ink
U051/U052/U053/U059
in An Error
Message Is Displayed on the LCD
and take the
appropriate action.
"Waste tank full"/"Ink absorber full"
The ink absorber is nearly full.
See Contact service center
in
An Error Message Is
Displayed on the LCD
and take the appropriate
action.
"No ink"/"Ink cassette error"
The FINE Cartridge has or may have run out of
ink.
Appropriate FINE Cartridge is not installed.
Printing cannot be executed because the FINE
Cartridge is not compatible with this machine.
Install the appropriate FINE Cartridge.
If you want to cancel printing, press the
Seite 852 von 922 SeitenError Message Appears on a PictBridge Compliant Device