Canon MX360 Seires - An Error Message Is Displayed on the Lcd

Advanced Guide
>
Troubleshooting
> An Error Message Is Displayed on the LCD
U304
An Error Message Is Displayed on the LCD
If an error message is displayed on the LCD, take the corresponding action described below.
Message
Action
Check ink
U051/U052/U053/U059
The FINE Cartridge may not be installed properly,
or the Cartridge may not be compatible with this
machine.
Open the Scanning Unit (Cover) and install the
appropriate FINE Cartridge. After that, push the Ink
Cartridge Locking Cover until it clicks into place,
then close the Scanning Unit (Cover).
If the error is not resolved, the FINE Cartridge may
be damaged. Contact the service center.
Check ink
U075/U076
Make sure that each FINE Cartridge is installed in
the correct position.
Routine Maintenance
Check ink
U140
Appropriate FINE Cartridge is not installed.
Printing cannot be executed because the FINE
Cartridge is not compatible with this machine.
Install the appropriate FINE Cartridge.
If you want to cancel printing, press the machine's
Stop
button.
Routine Maintenance
Check ink
U150
The FINE Cartridge cannot be recognized.
Replace the FINE Cartridge.
If the error is not resolved, contact the service
center.
Check ink
U162
The ink may have run out.
The function for detecting the remaining ink level
will be disabled since the ink level cannot be
correctly detected.
If you want to continue printing without this
function, press the machine's
Stop
button for at
least 5 seconds.
Canon recommends to use new genuine Canon
cartridges in order to obtain optimum qualities.
Please be advised that Canon shall not be liable
for any malfunction or trouble caused by
continuation of printing under the ink out condition.
Note
If the function for detecting the remaining ink
level is disabled, is displayed on the
LCD.
Routine Maintenance
Since the information contained in the fax
may be lost if it is printed in this condition, the
received fax will not be printed and will be
stored in the machine's memory until the ink
cartridge is replaced. You must manually
print out faxes that were stored in the
memory. You can change the setting so that
the received fax is forcibly printed out instead
of being stored in the memory, but all or part
of the fax information may not be printed
because of the ink out condition.
Seite 801 von 922 SeitenAn Error Message Is Displayed on the LCD